Yealink CP920 - Time & Date

User Guide for the CP920 HD IP Conference Phone
32
To change the language for the web user interface:
1. Select the desired language from the pull-down list at the top-right corner of web user
interface.
Text displayed on the web user interface will change to the selected language.
Time & Date
The time and date are displayed on the LCD screen when the phone is idle. You can configure
the phone to obtain the time and date from the Simple Network Time Protocol (SNTP) server
automatically, or configure the date and time manually. If the phone cannot obtain the time
and date from the SNTP server, contact your system administrator for more information.
To configure the SNTP settings via phone user interface:
1. Tap Menu->Settings->Basic Settings->Time & Date->SNTP Settings.
2. Tap the or soft key to select the time zone that applies to your area from the Time
Zone field.
The default time zone is "+8".
3. Enter the domain name or IP address in the NTP Server1 and NTP Server2 field
respectively.
4. Tap the or soft key to select the desired value from the Daylight Saving field.
5. Tap the or soft key to select the desired time zone name from the Location field.
This field appears only if Daylight Saving field is selected to Automatic.
The default time zone name is “China(Beijing)”.
6. Tap the Save soft key to accept the change or the Back soft key to cancel.
Note
Please refer to Appendix A – Time Zones for the list of available time zones on the IP phone.