User Guide for the CP920 HD IP Conference Phone
92
Call Waiting
You can enable or disable call waiting on the phone. If call waiting is enabled, you can receive
another call while there is already an active call on the phone. Otherwise, another incoming call
is automatically rejected by the phone with a busy message when there is an active call on the
phone. You can also enable or disable the phone to play a warning tone when receiving
another call.
To configure call waiting via phone user interface:
1. Tap Menu->Features->Call Waiting.
2. Tap the or soft key to select Enabled from the Call Waiting field.
3. Tap the or soft key to select Enabled from the Play Tone field.
4. (Optional.) Enter the call waiting on code or off code respectively in the On Code or Off
Code field.
5. Tap the Save soft key to accept the change or the Back soft key to cancel.
Call waiting is configurable via web user interface at the path Features->General Information.
Conference
You can create a conference with other four parties using the phone’s local conference. You can
view and manage each participant in the conference call. The CP920 IP conference phone also
supports network conference. The network conference URI should be predefined, contact your
system administrator for more information.
Note
Local Conference
The CP920 IP conference phone supports up to five parties (including yourself) in a conference
call. The default conference type is Local Conference.
Initiating a Conference by Inviting Participants
To initiate a conference by inviting Participants:
1. Place a call to the first party.
Network conference is not available on all servers. For more information, contact your system
administrator.
To Next Page
Loading...
