Yealink T58A

| Device Network | 14
The following table lists the parameters you can use to configure IPv6.
Parameter static.network.ipv6_internet_port.type
[1]
<MAC>.cfg
Description
It configures the Internet port type for IPv6.
Note: It works only if “static.network.ip_address_mode” is set to 1 (IPv6) or 2 (IPv4
& IPv6).
Permitted Values
0-DHCP
1-Static IP
Default 0
Web UI Network > Basic > IPv6 Config > Configuration Type
Phone UI
> Settings > Device Settings > Network (default password: admin) > WAN
Port > IPv6 Type
Parameter static.network.ipv6_internet_port.ip
[1]
<MAC>.cfg
Description
It configures the IPv6 address.
Note: It works only if “static.network.ip_address_mode” is set to 1 (IPv6) or 2 ( IPv4
& IPv6), and "static.network.ipv6_internet_port.type" is set to 1 (Static IP).
Permitted Values IPv6 Address
Default Blank
Web UI Network > Basic > IPv6 Config > Configuration Type(Static IP) > IP Address
Phone UI
> Settings > Device Settings > Network (default password: admin) > WAN
Port > IPv6 Type(Static IP) > IP Address
Parameter static.network.ipv6_prefix
[1]
<MAC>.cfg
Description
It configures the IPv6 prefix.
Note: It works only if “static.network.ip_address_mode” is set to 1 (IPv6) or 2 ( IPv4
& IPv6), and "static.network.ipv6_internet_port.type" is set to 1 (Static IP).
Permitted Values Integer from 0 to 128
Default 64
Web UI Network > Basic > IPv6 Config > Configuration Type(Static IP) > IPv6
Prefix(0~128)
Phone UI
> Settings > Device Settings > Network (default password: admin) > WAN
Port > IPv6 Type(Static IP) > IPv6 IP Prefix(0~128)
Parameter static.network.ipv6_internet_port.gateway
[1]
<MAC>.cfg
Description
It configures the IPv6 default gateway.
Note: It works only if “static.network.ip_address_mode” is set to 1 (IPv6) or 2 ( IPv4
& IPv6), and "static.network.ipv6_internet_port.type" is set to 1 (Static IP).