Yealink T58A - Redial + Call (History) Lists; Getting to Know Your Directory; Directory Operations

| Device Network | 15
Permitted Values IPv6 Address
Default Blank
Web UI Network > Basic > IPv6 Config > Configuration Type(Static IP) > Default
Gateway
Phone UI
> Settings > Device Settings > Network (default password: admin) > WAN
Port > IPv6 Type(Static IP) > Default Gateway
Parameter static.network.ipv6_static_dns_enable
[1]
<MAC>.cfg
Description
It triggers the static IPv6 DNS feature to on or off.
Note: It works only if “static.network.ipv6_internet_port.type” is set to 0 (DHCP).
Permitted Values
0-Off, the device will use the IPv6 DNS obtained from DHCP.
1-On, the device will use manually configured static IPv6 DNS.
Default 0
Web UI Network > Basic > IPv6 Config > IPv6 Static DNS (or Static IPv6 DNS)
Parameter static.network.ipv6_primary_dns
[1]
<MAC>.cfg
Description
It configures the primary IPv6 DNS server.
Note: It works only if “static.network.ip_address_mode" is set to 1 (IPv6)
or 2 (IPv4 & IPv6). In DHCP environment, you also need to make sure
“static.network.ipv6_static_dns_enable" is set to 1 (On).
Permitted Values IPv6 Address
Default Blank
Web UI Network > Basic > IPv6 Config > Configuration Type(Static IP) > Primary DNS
Or Network > Basic > IPv6 Config > Configuration Type(DHCP) > Static
DNS(Enable) > Primary DNS
Phone UI
> Settings > Device Settings > Network (default password: admin) > WAN
Port > IPv6 Type(Static IP) > Pri.DNS
Or > Settings > Device Settings > Network (default password: admin) >
WAN Port > IPv6 Type(DHCP) > IPv6 Static DNS(Enable) > Pri.DNS
Parameter static.network.ipv6_secondary_dns
[1]
<MAC>.cfg
Description
It configures the secondary IPv6 DNS server.
Note: It works only if “static.network.ip_address_mode" is set to 1 (IPv6)
or 2 (IPv4 & IPv6). In DHCP environment, you also need to make sure
“static.network.ipv6_static_dns_enable" is set to 1 (On).
Permitted Values IPv6 Address
Default Blank