Yealink T58A - Page 45

| Device Provisioning | 45
• Auto Provisioning Settings Configuration
Auto Provisioning Settings Configuration
The following table lists the parameters you can use to configure settings for auto provisioning.
Parameter static.network.attempt_expired_time
[1]
<y0000000000xx>.cfg
Description
It configures the timeout interval (in seconds) to transfer a file for HTTP/HTTPS
connection.
Permitted Values Integer from 1 to 20
Default 10
Parameter static.auto_provision.power_on <y0000000000xx>.cfg
Description It configures the device whether to perform the auto provisioning when powered
on.
Permitted Values
0-Off
1-On, the device will perform the auto provisioning when powered on.
Default 1
Web UI Settings > Auto Provision > Power On
Parameter static.auto_provision.repeat.enable <y0000000000xx>.cfg
Description
It triggers the repeatedly feature to on or off.
Permitted Values
0-Off
1-On
Default 0
Web UI Settings > Auto Provision > Repeatedly
Parameter static.auto_provision.repeat.minutes <y0000000000xx>.cfg
Description
It configures the interval (in minutes) for the device to perform the auto
provisioning repeatedly.
Note: It works only if “static.auto_provision.repeat.enable” is set to 1 (On).
Permitted Values Integer from 1 to 43200
Default 1440
Web UI Settings > Auto Provision > Interval(Minutes)
Parameter static.auto_provision.weekly.enable <y0000000000xx>.cfg
Description It triggers the device to perform the auto provisioning weekly.
Permitted Values
0-Off
1-On, the device will perform an auto provisioning process weekly.
Default 0
Web UI Settings > Auto Provision > Weekly
Parameter static.auto_provision.weekly.dayofweek <y0000000000xx>.cfg