Using the VC400 Video Conferencing System
115
To adjust the remote camera to the preset via the remote control during a video call:
1. Press (More soft key) during an active call.
2. Press or to scroll to Near/Far Camera, and then press .
3. Select the remote video, and then press .
4. Press (More soft key).
5. Press or to scroll to Camera Preset, and then press .
6. Short press the saved key to change remote camera position and focus to the preset (The
preset is set by the remote system in advance).
7. Press (Exit soft key) to return to the idle screen.
To clear preset via the remote control:
1. Press (Menu soft key) to enter main menu.
2. Press or to select the Video & Audio menu.
3. Press or to scroll to Camera General Settings, and then press .
4. Press or to scroll to Clear Preset Position, and then press .
5. Select Ok, and then press to delete all presets.
Changing the Video Input Source
VC400 video conferencing system supports these video input sources: camera and PC.
When the camera and PC are connected to the VC400 codec, the display device displays the
presentation on the connected PC. If two display devices are connected to the VC400 codec, the
video image is shown on the main display device, and the presentation is shown on the
secondary display device.
During a call, the display device will display differently depending on whether it has been
connected to a secondary display device and the video input source you select. You can change
the video input source via the remote control and web user interface.
To change video input when the system is idle via the remote control:
1. Press .
The display device shows Camera and PC input sources.
2. Press or to select the desired input source, and then press .
The display device shows the selected source.
To change video input during a call:
1. Press .
The display device shows Camera, Camera and PC and PC input sources.
2. Press or to select the desired input source, and then press .
The display device shows the selected source.
Video input is configurable via web user interface at the path Home->Input.
To Next Page
Loading...
