Yealink VC400 - Customizing the VC400 Video Conferencing System; General Settings; Automatic Sleep Time

Customizing the VC400 Video Conferencing System
43
Customizing the VC400 Video Conferencing
System
You can customize your VC400 video conferencing system by personally configuring certain
settings, for example, site name, time & date and language. You can add contacts to the local
directory manually or from the call history.
This chapter provides basic operating instructions for customizing your system. Topics include:
 General Settings
 Directory
 Call History Management
 Call Protocol
 Bandwidth Settings
 Audio Setting
 Far-end Camera Control
If you require additional information or assistance with your new system, contact your system
administrator.
General Settings
Automatic Sleep Time
The system will enter the sleep mode automatically when it has been inactive for a period of
time (the default period is 10 minutes).
When the system is in sleep mode, it will still accept incoming calls. The display device will
prompt “No Signal”, and the VCP40 phone LCD screen prompts “Sleeping Press any key to
resume”. You can press any key on the remote control or VCP40 phone to wake the system up.
When receiving a call, the system will be woken up automatically.
You can change the automatic sleep time via the remote control or web user interface. You can
also press the sleep key on the remote control to make the system sleep immediately.
To configure the automatic sleep time via the remote control:
1. Press (Menu soft key) to enter main menu.
2. Press or to select the Basic menu.
3. Press or to scroll to Automatic Sleep Time, and then press .
4. Select desired time from the pull-down list of Automatic Sleep Time.