Getting Started
27
6. Lock the camera to the L-bracket, and then connect the other end of the DVI cable to the
VC400 codec.
Installing Batteries for the Remote Control
Do the following:
1. Open the battery cover on the back of the remote control.
2. Insert the batteries with correct polarity.
3. Replace the battery cover.
Remote Control Battery Safety Information
Never make wrong polarity connection when charging and discharging battery packs.
Avoid crushing, puncturing, or putting a high degree of pressure on any battery, as this can
cause an internal short-circuit, resulting in overheating.
Remove the batteries if they are not in use for long period of time. Battery leakage and
corrosion can damage the remote control, dispose batteries safely.
Do not dispose used batteries in domestic waste. Dispose batteries at special collection
points or return to stores if applies.
Do not dispose batteries in a fire.
To Next Page
Loading...
