Yealink VC400 - Page 91

Customizing the VC400 Video Conferencing System
79
To configure the uplink and downlink bandwidth via the remote control:
1. Press (Menu soft key) to enter main menu.
2. Press or to select the Call Features menu.
3. Press or to scroll to Bandwidth Settings, and then press .
4. Select desired bandwidth from the pull-down list of Uplink Bandwidth.
If Auto is selected, the system will select the appropriate bandwidth automatically.
5. Select desired bandwidth from the pull-down list of Downlink Bandwidth.
If Auto is selected, the system will select the appropriate bandwidth automatically.
6. Press (Save soft key) to accept the change.
Note
Bandwidth is configurable via web user interface at the path Setting->Call Features->Uplink
Bandwidth/Downlink Bandwidth.
The priority of bandwidth is as follows:
System bandwidth > Contact bandwidth (refer to Adding Contacts).
For example: the system bandwidth is 512kbps, if contact bandwidth is set to a value greater than
512bps, then the actual contact bandwidth will be 512bps. If contact bandwidth is set to a value
less than 512bps, then the actual contact bandwidth will be the value set by user.