Yealink W53P

Yealink W53P & W60P User Guide
26
1. Navigate to OK->Settings->System Settings->Change Base PIN.
2. Enter the system PIN (default: 0000), and then press Done.
3. Enter the new PIN in the Enter New PIN and Re-enter New PIN field respectively.
4. Press Save.
Note
We recommend that you set a new random 4-digit PIN that may not be easily guessed.
Changing the Wallpaper
You can change the wallpaper image when the handset is idle.
Procedure
1. Navigate to OK->Settings->Display->Wallpaper.
2. Press the navigation keys to select the desired image.
3. Press Save.
Setting the Screen Saver
The screen saver is designed to protect your phone screen by filling it with an analog clock. When the screen saver is
enabled, an analog clock will be activated and appear on the phone screen if the handset is idle for approximately 10
seconds.
Procedure
1. Navigate to OK->Settings->Display->Screen Saver.
2. Press Change.
Changing the Screen Brightness
The handset backlight in charger or out of charger can be configured independently.
When in charger/out of charger is enabled, the backlight will be turned off after the handset is idle for about 30
minutes when the handset is or not in the charging cradle. When an incoming call arrives, a key is pressed or the the
handset status changes, the backlight is automatically turned on.
Procedure
1. Navigate to OK->Settings->Display->Display Backlight.
2. Select the desired value from the In Charger or Out Of Charger field.
3. Press Save.
Setting the Keypad Light
You can enable the keypad light to illuminate the keypad keys when any key is pressed.
Procedure
1. Navigate to OK->Settings->Display->Keypad LED.
2. Press Change.