Yealink W53P

Call Features
59
Managing a Paging Call
Sending Multicast Paging
Before You Begin
Your system administrator has set the paging group for your phone.
Procedure
1. Navigate to OK->Call Features->Paging.
2. Select the desired paging group.
3. Press Paging.
Note
Multicast RTP is one way only from the sender to the multicast address(es) (receiver). For outgoing RTP multicasts, all other
existing calls on the phone will be placed on hold.
Receiving Multicast Paging
Your system administrator has set a listening paging group for you, and then you can receive a paging call when the
phone is idle. The paging call is automatically answered on your phone.
When there is a voice call or a paging call in progress, the phone handles the new paging call differently according to
the multicast listening settings configured by your system administrator.
Managing a Paging Call
During a paging call, you can do the following:
l Press Hold to place the current paging call on hold.
The paging call is placed on hold and the receiver releases the session.
l Press Resume to resume the held paging call.
The multicast RTP session is re-established.
l Press End Call to end the paging call.