Yealink W53P

Call Features
57
1. Place a call to the first party.
2. When the first party answers the call, press Options->Conference to place a new call.
3. Enter the number of the second party to dial out.
The active call is placed on hold.
4. When the second party answers the call, press Conf. again to join all parties in the conference.
Joining Two Calls in a Conference
You can invite a held call into a conference call with the active call.
Procedure
1. Place two calls using the same or different accounts on the phone.
2. Select the desired call for a conference and ensure that the call is active.
3. Press Options->Conference.
Muting or Unmuting a Conference Call
You can mute the local microphone during a conference call so that the other two participants can hear each other
except you.
Procedure
1. Press the MUTE key to mute the conference.
2. Press the MUTE key again to unmute the conference.
Ending a Conference Call
Procedure
1. The conference initiator presses the On-hook key or End.
If any party in the conference ends the call, the other parties remain connected.
Network Conference
If your system administrator has set a network conference feature on your phone, you can initiate a conference with
multiple participants.
Topic
Setting Up a Network Conference
Inviting another Party into an Active Conference Call
Holding/Resuming a Conference Call
Ending a Conference Call
Setting Up a Network Conference
Procedure
1. Place a call to the first party.
2. Press Options->Conference to place a new call.
The active call is placed on hold.
3. Enter the number of the second party, and then press the OK key or Conf..
4. When the second party answers the call, press Conf. to add the second party to the conference.
5. Press Conference to place a new call.