Yeastar Technology S20 Administrator's Guide

S-Series IP PBX Administrator Guide
118
The example configurations are set according to S-Series LDAP default settings. You can use the
below settings as a starting point and adjust the filter and display attributes according to your needs.
Field
Value
LDAP Name Filter
(|(cn=%)(sn=%))
LDAP Number Filter
(|(telephoneNumber=%)(homePhone=%)(mobile=%))
Server Address
192.168.6.218 /the IP of Yeastar S-Series/
Port
389
Base
dc=pbx,dc=com
User Name
cn=admin,dc=pbx,dc=com
Password
****** /the password you have set on Yeastar S-Series/
Max. Hits
50
LDAP Name Attributes
cn sn displayName
LDAP Number Attributes
telephoneNumber homePhone mobile mail
departmentNumber
LDAP Display Name
%cn
Protocol
Version 3
Search Delay(ms)(0~2000)
0
LDAP Lookup for Incoming Call
Enabled
LDAP Sorting Results
Enabled
LDAP Lookup for Pre Dial/Dial
Enabled
To configure LDAP DSS Key:
You can set a DSS key to be an LDAP key, and then press the LDAP key to enter the LDAP search
screen when the IP phone is idle.
1. Click on DssKey > Memory Key.
2. In the desired DSS key field, select LDAP from the pull-down list of Type.
3. Click Confirm to accept the change.

Yeastar Technology S20 Specifications

General

Brand	Yeastar Technology
Model	S20
Category	PBX
Language	English