S-Series IP PBX Administrator Guide
69
Table 7-8 DISA Configuration Parameters
Give this DISA a brief name to help you identify it.
The password for this DISA.
The maximum amount of time the system will wait before hanging up
the call if the user has dialed an incomplete or invalid number. The
default value is 10s.
The maximum amount of time permitted between each digit when the
user is dialing an extension number. The default value is: 5s.
Defines the outbound routes that can be accessed from this DISA.
Blacklist/Whitelist
Blacklist is used to block an incoming/outgoing call. If the number of incoming or outgoing call is
listed in the number blacklist, the caller will hear the following prompt: “The number you have dialed
is not in service. Please check the number and try again”. The system will then disconnect the call.
Whitelist is used to allow incoming/outgoing numbers.
The system supports to block or allow 3 types of numbers:
4) Inbound: the number would be disallowed or allowed to call in the system.
5) Outbound: users are disallowed or allowed to call the number out from the system.
6) Both: both inbound and outbound calls are disallowed or allowed.
1) Add Blacklist/Whitelist
Select Blacklist or Whitelist tag, click to add a number to Blacklist or Whitelist.
Figure 7-9 Add Blacklist
7) Name: give a name for the blacklist/whitelist.
8) Number: enter the numbers, one number per row.
9) Type: choose the type.
To Next Page
Loading...
Need help?
General
