S-Series IP PBX Administrator Guide
55
Allow the users to specify the number of digits that will be stripped from the front of the phone
number before the call is placed.
For example, if users must press 0 before dialing a phone number, one digit should be stripped
from the dial string before the call is placed.
Digits to prepend to a successful match. If the dialed number matches the patterns, then this will be
prepended before sending to the trunks.
For example if a trunk requires 10-digit dialing, but users are more comfortable with 7-digit dialing,
this field could be used to prepend a 3-digit area code to all 7-digit phone numbers before the calls
are placed. When using analog trunks, a “w” character may also be prepended to provide a slight
delay before dialing.
3) Member Trunks
Select which trunks will be used in this route.
Figure 6-3 Member Trunks
4) Member Extensions
Select extensions that will be permitted to use this outbound route.
Figure 6-4 Member Extensions
To Next Page
Loading...
Need help?
General
