YOKOGAWA PH450G User Manual

<7. COMMISSIONING OF SC (Conductivity)>
7-13
IM 12A01A02-01E 8th Edition : Oct. 01, 2015-00
For more information on HART communication, see the Technical Information (TI 12A01A02-
60E) in the attached CD-ROM.
n PH201G
Select this menu if the PH201G distributor is connected to the instrument.
In the PH201G setup screen, make settings for “Hold contact,” and “Fail contact.”
l Hold contact
Select Disabled or Enabled.
When this item is enabled, the output will be held according to the setting of “Hold type” on the
Hold setup screen.
l Fail contact
Select a status from among “Fail + Warn,” “Fail only,” and “Disabled.”
This setting depends on the error conguration. See “7.3 Error conguration.”
“Fail” corresponds to “Fault.”
7.5.6 Factory setup
For “Factory setup,” there is no item to be set by the user.
NOTE
This menu is for service engineers only. This section is protected by a password. Attempting to
change data in the factory adjustment menu without the proper instructions and equipment could
result in corruption of the instrument setup and damage the performance of the unit.
7.6 Display setup
This screen is used to make various settings relating to screen display.
NOTE
Settable items differ depending on settings in “Measurement setup.”
7.6.1 Main display (Dual display, Individual display)
Main display
Trend
Auto Return
Ad.just contrast
MONITOR display
Display setup
Dual display
Individual display
Trend
Auto Return
Adjust contrast
MONITOR display
or
Display setup
Figure 7.3 Display setup screens for a single module (left) and two modules (right)
SC
7

YOKOGAWA PH450G Specifications

General

Brand	YOKOGAWA
Model	PH450G
Category	Measuring Instruments
Language	English