EasyManuals Logo

Zebra Z Series User Manual

Zebra Z Series
156 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #117 background imageLoading...
Page #117 background image
117
Troubleshooting
LCD Error Messages
6/6/08 Z Series
®
/RZ™ Series User Guide 79695L-002 Rev. A
The printer prints while the
ERROR light flashes.
Caution • An improperly connected printhead data or power cable
can cause this error message. The printhead may be hot enough to
cause severe burns. Allow the printhead to cool.
The printhead temperature is
approaching its lower operating
limit.
Continue printing while the printhead
reaches the correct operating
temperature. If the error remains, the
environment may be too cold for
proper printing. Relocate the printer to
a warmer area.
The printhead data cable is not
properly connected.
Caution • Turn off (O) the printer
before performing this procedure.
Failure to do so can damage the
printhead.
1. Turn off (O) the printer.
2. Disconnect and reconnect the data
cable to the printhead.
3. Ensure that the cable connector is
fully inserted into the printhead
connector.
4. Turn on (
I) the printer.
The printhead has a faulty
thermistor.
Call a service technician.
The printer stops; the
ERROR light flashes.
Caution • The printhead may be hot enough to cause severe
burns. Allow the printhead to cool.
The printhead is over temperature. Allow the printer to cool. Printing
automatically resumes when the
printhead elements cool to an
acceptable operating temperature.
Table 16 • LCD Error Messages (Continued)
LCD Display/
Printer Condition
Possible Cause Recommended Solution
WARNING
HEAD COLD
WARNING
HEAD TOO HOT

Table of Contents

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the Zebra Z Series and is the answer not in the manual?

Zebra Z Series Specifications

General IconGeneral
Print MethodThermal Transfer or Direct Thermal
Max Print Width4.09 in./104 mm (depending on model)
Max Print Length39 in./991 mm (with 203 dpi)
ConnectivityUSB, Serial (depending on model)
Supported Media TypesWristbands
Media Width1.0 inch (25.4 mm)
Operating Temperature40°F to 104°F (5°C to 40°C)
Storage Temperature-40° F/-40° C to 140° F/60° C
Resolution203 dpi or 300 dpi (depending on model)

Related product manuals