Safety
Carl Zeiss General Notes, Instrument Safety and EMC Axiostar plus
VI B 40-815 e 12/01
General Notes on Safety
Before starting up the microscope, please
ensure that you have familiarized yourself
thoroughly with the contents of this manual.
Further information can be obtained from our
service department or from authorized
representatives.
The Axiostar plus microscope is an optical
precision instrument which may be impaired in
its performance or damaged if handled
improperly.
The microscope must be operated by trained
personnel only who must be aware of the
possible problems involved with microscopy and
who are trained in the relevant application.
To ensure that the working procedure is safe
and that the microscope functions without
problems, the notes and warnings included in
the operating instructions must be observed.
These are highlighted in the text by the
following symbols:
CAUTION!
If the safety notes are not observed there is a
risk for the user.
CAUTION!
Disconnect the instrument from the line.
CAUTION
!
Hot surface; there is a risk of burns.
CAUTION!
If the safety notes are not observed, there is a
risk that the instrument will be destroyed.
☞
NOTE!
Notes that must be observed when working
with the microscope.
Instrument Safety and EMC
The Axiostar plus microscope was designed,
produced and tested in compliance with DIN EN
61010-1 (IEC 1010-1) “Safety requirements for
electrical measuring, control and laboratory
instruments“. It left the factory in a perfectly
safe condition.
The Axiostar plus microscope meets the
requirements of the EC directives 73/23/EC-
appendix 1 and 89/336/EC and the EMC
legislation of 09/18/1998:
Radio interference suppression in accordance
with EN 55011 class B
Resistance to jamming in accordance with EN
50082-2
Conformity with the above EC directives is
documented by the CE symbol.
Artisan Scientific - Quality Instrumentation ... Guaranteed | (888) 88-SOURCE | www.artisan-scientific.com
To Next Page
Loading...
