Intensity
Once fixtures are patched into your console, all intensities can be controlled in exactly the same way – no matter if the
fixture is a basic dimmer, an LED, a moving light or any other type of fixture. There are three possible ways to control
an intensity.
Click for more on controlling intensity with...
Multi-Functional Faders (MFFs)
Commands
Encoder wheels
MFFs
Ensure that the MFFs (Multi-Functional Faders) are in channel mode by pressing the Fader Funct. button. When set
to “Channels”, the MFFs directly control each light (or “fixture”) in the rig (this is often referred to as “Channel per
Fader”). Each fixture, no matter what it is, will have a single “Channel Number”, and so will take up a single channel
fader. The Page button(s) can be used to switch between channels (99 pages of 24 channels on FLX, two pages of 48
channels on FLX S48, and two pages of 24 channels on the FLX S24). Grey outline boxes in the Output Window show
which set of channels are currently being controlled on the MFFs. Channels can be adjusted by moving the
appropriate fader. If a channel already has a level, for example being played back from a cue, then you must ‘grab’ the
level by moving the fader up to the present value. Once that value is grabbed, the fader gains control.
When your MFFs are controlling Channels rather than Playbacks, the
Faders window will show you the names of the fixture's you are
currently controlling, and their intensity percentages.
Commands
Zero 88 - ZerOS - Page 60 of 233 Printed: 23/11/2020 12:50:03 JH
To Next Page
Loading...
Need help?
General
