Zetor FORTERRA 95 - Possible Adjustable Tracks of the Front Wheels of the Front Driving Axle of the Tractors

108
WHEEL TRACK CHANGE
POSSIBLE ADJUSTABLE TRACKS OF THE FRONT WHEELS OF THE FRONT
DRIVING AXLE OF THE TRACTORS
Used tyres
12.4-24 13.6R24 12.4-28 14.9-24
12.4R24 380/70R24 14.9R24 Rim position
420/70R24
Front wheel tracks in mm
1590∗
- - -
1645 1730 1730
1740 1655 1730 -
1800 1880 1810 1880
1890 1810 1880 1810
1945 2030 1955 2030
2040 1955 2030 1955
Note: Use of different tyre dimensions
with individual tractor types - see chapter
Main technical parameters.
Tighten the front wheel nuts with the
torque of 250 - 290 Nm.
Tighten the nuts connecting the wheel
bead with the wheel disc with the torque
of 200 - 220 Nm.
You can change the wheel track by
changing the position of the rim and disc.
First, secure the tractor against
moving, lift the axle with a lifting
jack and support it.
− Loosen the nuts of the screws
connecting the disc with the rim and
remove the screws.
− Change the track by setting the rim in
the required position.
− Re-install the screws with washers and
secure them with nuts. Tighten the
nuts with the torque of 230 - 250 Nm.
− After every loosening of a bead
connection tighten the screws to the
prescribed value.
− After driving 100 m with the tractor
without load re-tighten the connections
with the prescribed torque.
− After loading the tractor re-tighten the
connections after 3 hours of work.
− After 10 hours of work check the
tightening of the nuts of discs and
wheel rims again.