158
MAINTENANCE INSTRUCTIONS
F_02_111 C730 C731
AFTER DRAINING OIL
1. Clean the magnet (it is part of the lid)
and the strainer element of the
suctioning filter (2)
2. Replace the filter element (1) Tighten
the cleaner bowl screw by hand, do not
use any tools
3. After cleaning screw all the drain
screws back on.
4. Fill oil (approx. 40 litres), start the
engine and let it run for approx. 2
minutes
5. After stopping of the engine and
stabilization of the oil level in the
gearbox check its quantity and fill up
oil to the upper edge of the dipstick
tab or if increased filling is necessary,
to the lower or upper mark of the
dipstick.
LUBRICATION AND FILLING POINTS
OF THE FRONT DRIVING AXLE
1. Lubricating nipple of the kingpin
2. Sliding bearings (2 pieces) of the
front driving axle
3. Drain opening of the final drive
housing oil
4. Filling and inspection opening of final
drive housing oil (after removing of
the inspection screw the oil level
must reach the bottom edge of the
inspection opening)
FILLING, INSPECTION AND DRAIN
OPENING OF OIL OF THE FRONT
WHEEL REDUCERS
Oil is checked, filled and drained through
one opening after turning of the reducer
in accordance with the figure.
1. Checking the oil level - opening on
the horizontal axis of the reducer
(after removing of the inspection
screw the oil level must reach the
bottom edge of the inspection
opening)
2. Oil filling - opening at the top
3. Oil draining - opening at the bottom
To Next Page
Loading...
