175
ADJUSTMENT
F_02_129 F_02_130 F_02_131
CALIBRATION OF THE TRAVELLING SPEED OF THE DIGITAL DASHBOARD
After the assembly in the production
plant the dashboard is calibrated.
Perform repeated calibration:
− In case of a considerable wear of the
tyres
− When installing new tyres
− When replacing the dashboard.
CALIBRATION SEQUENCE
− In a suitable area mark a 100m long
track.
− Inflate the tractor tyres to the prescribed
pressure, see the tables of this Man-
ual.
− Start the engine.
− Drive the tractor to the beginning of the
100m track.
− Simultaneously press the button (A)
and button (B). Hold the buttons de-
pressed for 7 s. The dashboard is
switched over to the calibration mode.
“Start” will start flashing on the dis-
play.
− Press the button (B). “Stop” will start
flashing on the display.
− Drive the tractor at a steady speed of
approx. 10 km/h.
− The display will show the number of im-
pulses detected by the travelling sen-
sor.
− After covering the whole distance of
100 m stop the tractor at the marked
end of the track (see fig. F_02_129).
− Press the button (B). This way you will
save the number of impulses detected
by the travelling sensor in the memory.
The dashboard is calibrated and ready
for operation.
To Next Page
Loading...
