96
ELECTRO-HYDRAULIC SYSTEM
F_02_98 F_02_78 F_02_65
USING THE REAR CONTROL
The rear control is used to connect and
disconnect implements. The lifting
switching lever (1) on the EHR-B electro-
hydraulic control panel must be in posi-
tion (b) or (c). The designation symbols
of buttons on both the tractor fenders
correspond to the movement direction of
the three-point hitch after their pressing.
The movement only lasts as long as the
button is held.
Every use of the rear control causes
blocking of the control system and the
“Blocking cancellation” must be repeated
- see page 130.
EXTERNAL CONTROL BUTTONS OF
THE ELECTRO-HYDRAULIC SYSTEM
1. Lifting
2. Lowering
The movement only lasts as long as the
buttons are held.
The external control buttons of the
electro-hydraulic system are func-
tional without prior activation of
the system.
USING THE BUTTONS
When handling the three-point
hitch with the external control but-
tons the operator must stand out
of reach of the connected imple-
ment to avoid being caught or in-
jured by the implement.
To Next Page
Loading...
