77
DRIVE OF AGRICULTURAL MACHINES
F_02_179 F73
CONTROL OF THE FRONT AND REAR PTO
The clutches of the PTO’s are switched on (at the min. engine speed of 1500 rpm)
and off electro-hydraulically.
The switching is performed with the use of switches located on the right cab pillar.
The switches are equipped with mechanical locks (1) against accidental activation.
When using a switch, press the lock downwards.
P -
The switch controls the
electromagnetic valve of the front
PTO
Z -
The switch controls the valve of
the rear PTO
By pressing both the switches you will activate both the PTO’s (front and rear).
Activation of the PTO’s is indicated by the illuminated symbol on the switch.
REAR PTO - SELECTION OF
DEPENDENT AND INDEPENDENT
SPEED (RPM)
PTO -
Independent rpm of the
PTO engaged
N -
Neutral position
Use this position to facilitate
the connection of the
articulated shaft of an
agricultural machine.
The end piece of the rear
PTO can be rotated freely.
PTO
synchro -
Dependent rpm of the PTO
engaged (the rpm value
depends on the travelling
speed of the tractor)
To Next Page
Loading...
