171
ADJUSTMENT
F_02_205
F284
ADJUSTING THE PLAY OF THE
CLUTCH PEDAL
The proper play between the pedal pis-
ton rod and the piston of the main cylin-
der is not adjusted - it is set by the manu-
facturer. What should be adjusted is the
mutual position of the piston rod and pis-
ton rod lug (1) so that the piston rod can
be extended from the cylinder as much
as possible and the play between the
pedal and the upper stop screw (2) can
be 0.1 - 0.2 mm at the same time. Then,
the piston rod is secured with the nut (3)
with regard to the lug. After the adjust-
ment check whether the dust cap of the
cylinder is not deformed and repair it by
hand if necessary.
BLEEDING THE HYDRAULIC CIRCUIT
OF THE CLUTCH
Do the bleeding in the same way as in
the case of bleeding of the brake system.
The bleeding screw of the clutch disen-
gagement hydraulic circuit is located on
the clutch disengagement cylinder (1).
After two years you must replace
the brake liquid in the whole
brake circuit, including the clutch
disengagement hydraulic circuit.
To Next Page
Loading...
