General principles of new tractor ru
-in in first 100 hours of operatio
G251
During first 100 hours of operation:
z Load tractor in a normal way, avoid operation with low or maximum engine revolutions
z Avoid operation under partial loading of the engine
z Avoid excessive idle run operation
z Check oil levels in engine often (during this time increased oil consumption is normal)
z Check screw joints in particular in supporting parts of tractor
z Learned insufficiencies to be removed immediately, you will thus prevent subsequent damage or
endangered operation
z Keep the same procedure also after tractor complete overhaul
In first 10 hours of operation
From 100 hours of operation
z perform run-in in traffic
z tighten fastening nuts of front and rear wheels including
connectionbead / rim with prescribed torque
G252
fter drive in completion you can work with tractor without
limitations.
Recommended
operation
revolutions
1,400 - 2,300
rpm
Idle run revolutions 800 ± 25 rpm
Operation oil
pressure
0.2 - 0.5 MPa
Oil pressure with
idle run revolutions
min. 0.05 MPa
Max. coolant
temperature
106°C
E256
To Next Page
Loading...
Need help?
General