ZIEHL-ABEGG ECblue - Tacho Output F; Out; Message at Speed Deviation Fan Bad; Menu Group IO Setup

8.5.5 Tacho output f
out
Tacho out
See the function description Electrical installation / Open-Collector output “A1”
Setting
Function
OFF
A1 = Status output
ON
A1 = Tacho output (n = f x 60)
8.5.6 Message at speed deviation “Fan Bad”
Fanbad Speed
Speed deviation
Factory setting: 0 rpm
Setting range: 0 - 255 rpm
Fanbad Time
Time delay
Factory setting: 0 sec
Setting range: 0 - 255 sec.
8.6 Menu group IO Setup
IO Setup
Information
The following factory settings specifications are not binding, these values can differ depending on the
software version and customer-specific pre-setting.
8.6.1 Digital inputs “D1” (“E1” *)
D1 Function
Different functions can be assigned to the digital inputs “D1” and “E1”*.
Activation via floating contacts (a low voltage of approx. 10/24 V DC is connected).
“D1” is programmed for the “Enable” function at the factory.
D1 Inverting
For inverting switch to “ON”.
The input inversion is set at the factory to “OFF” (when a function is programming).
* If the analogue input “E1” is not required for specifying the fan speed, this can be used as a digital input (see E1 function).
The same functions can be assigned for “E1” as for “D1”.
Attention!
Never apply line voltage to the digital input!
Assembly instructions ECblue Programming by hand held terminal A-G-247NW
L-BAL-F055D-GB 2021/51 Index 006 Part.-No.
33/56