•
Even after disconnecting the mains voltage, life-threatening charges can appear between the
protective ground “PE” and the mains connection.
•
The protective earth is conducting high discharge currents (dependent on the switching frequency,
current-source voltage and motor capacity). Earthing in compliance with EN specifications shall
therefore be observed even for testing and trial conditions (EN 50 178, Art. 5.2.11). Without
earthing, dangerous voltages can be present on the motor housing.
•
Maintenance work may only be carried out by suitably qualifi ed personnel.
Attention, automatic restart!
•
The motor may switch on and off automatically for functional reasons.
•
Automatically restart after a power failure or mains disconnection!
•
Wait until the motor has stopped before approaching.
•
The exterior rotor turns during operation of the external rotor motor!
Danger of being sucked in!
Do not wear loose or hanging clothing, jewellery, etc., tie together long hair and cover it.
Attention, hot surface!
•
Temperatures of above 85 °C can occur on the motor surfaces, especially on the controller housing!
2.7 Modifications / interventions in the device
Attention!
For reasons of safety, no unauthorized interventions or modifications may be made on the device. All
planned modifications must be authorized by the manufacturer in writing.
Use only genuine spare parts / genuine wearing parts / genuine accessories from ZIEHL-ABEGG.Th-
ese parts were specifically designed for the device. There is no guarantee that parts from non-original
sources are designed and manufactured in correspondence with load and safety requirements.
Parts and optional equipment not supplied by ZIEHL-ABEGG are not approved by ZIEHL-ABEGG for
use.
2.8 Operator’s obligation of diligence
•
The contractor or owner must also ensure that the electric systems and equipment are operated
and maintained in accordance with electro-technical regulations.
•
The owner is obliged to ensure that the device is operated in perfect working order only.
•
The device may only be used as intended.
•
You must periodically examine the safety equipment for their properly functioning condition.
•
The assembly instructions and/or operating instructions are always readily available at the location
where the device is being used, are complete and are in legible condition.
•
These persons are regularly instructed in all applicable questions regarding occupational safety
and environmental protection and are knowledgeable regarding the assembly instructions and/or
operating instructions and, especially, are familiar with the safety instructions contained therein.
•
All safety and warning notices attached to the device are never removed and remain legible.
2.9 Employment of external personnel
Maintenance and service work are frequently carried out by external employees who often do not
recognize the specific situations and the thus resulting dangers.These persons must be comprehen-
sively informed about the hazards in their area of activity.
You must monitor their working methods in order to intervene in good time if necessary.
Assembly instructions ECblue Safety instructions
L-BAL-F055D-GB 2021/51 Index 006 Part.-No.
8/56
To Next Page
Loading...
Need help?
General
