To Next Page
J
Jeffrey LaneSep 1, 2025
What does it mean when my Zip Water System displays 'Hot Sensor Open'?
- RRonald WagnerSep 2, 2025
If your Zip Water System displays 'Hot Sensor Open', it indicates an internal sensor fault.
What does it mean when my Zip Water System displays 'Hot Sensor Open'?
If your Zip Water System displays 'Hot Sensor Open', it indicates an internal sensor fault.
What does 'Interface Fault' mean on my Zip HydroTap G5 BCS?
An 'Interface Fault' in your Zip Water System indicates an internal communication fault.
What does a 'Power Board Fault' mean on my Zip Water System?
A 'Power Board Fault' in your Zip Water System indicates an internal communication fault.
Why is the steam too cool in my Zip HydroTap G5 BCS Water System?
If the steam is too cool in your Zip Water System, it may be due to a boiling calibration error.
What does 'Boil dry protection' mean on my Zip Water System?
If your Zip Water System indicates 'Boil dry protection', it means the heating protection device has activated.
What does it mean when my Zip HydroTap G5 BCS indicates 'Over Steamed'?
If your Zip Water System indicates 'Over Steamed', it means that excess steam has been detected.
What does it mean when my Zip Water System displays 'Condenser Overtemp'?
If your Zip Water System displays 'Condenser Overtemp', it means the temperature of the condenser has exceeded its limit.
What does 'Hot Tank Overfilled' mean on my Zip Water System?
A 'Hot Tank Overfilled' message on your Zip Water System indicates that the hot tank has overfilled.
General| Brand | Zip |
|---|---|
| Model | HydroTap G5 BCS |
| Category | Water System |
| Language | English |
Critical safety guidelines and warnings for installation and operation.
Legal and regulatory compliance information for safe appliance use.
Specifications for HydroTap G5 models, including dimensions, power ratings, and weight.
Pre-installation checks to ensure all conditions are met for proper setup and operation.
Guidelines for ensuring adequate ventilation for the HydroTap Command Centre.
Details on the optional Water Block for leak limitation and water flow control.
Guidance on installing the optional booster heater for increased boiling capacity.
Procedures for securing and connecting the CO2 cylinder and regulator for sparkling models.
Detailed instructions for installing the HydroTap Command Centre based on model and tap type.
Steps for initial system setup, filter flush, and calibration after installation.
Information on common faults, troubleshooting steps, and recommended service items.
Guidelines for environmentally responsible disposal of the product according to regulations.
