ZIPWAKE DYNAMIC TRIM CONTROL SYSTEM - FOR INTEGRATION2
Documentation and technical accuracy
To the best of our knowledge, the information
in this document was correct at the time it was
produced. However, Zipwake cannot accept
liability for any inaccuracies or omissions it may
contain. In addition, our policy of continuous
product improvement may change specifications
without notice. As a result, Zipwake cannot
accept liability for any dierences between the
product and this document.
Fair use statement
You may print a copy of this manual for your
own use. You may not give or sell copies to third
parties and not in any way exploit the manual
commercially.
Product disposal
Dispose of this product in accordance with
the WEEE Directive.
The Waste Electrical and Electronic Equipment (WEEE)
The WEEE Directive does not apply to some
Zipwake parts; however we support its policy
and ask you to be aware of how to dispose of
this product.
Product Registration
Register your product online at
zipwake.com/register to allow notifications of
news and available software updates etc.
Disclaimer
Zipwake disclaims any responsibility for
loss of time, lifts, towing or transportation
costs or any other indirect, incidental
or consequential damage, injury,
inconvenience or commercial loss when
using this product. Zipwake will not
assume liability in case of damage arising
from improper use, improper installation or
modification of our products or accidents
involving them, or lost-profit claims by a
third party.
Trademark notice
Zipwake is a registered trademark of Prezip
Technology AB, Sweden. All other trademarks,
trade names, or company names referred to
herein are used for identification only and are
the property of their respective owners.
Patent notice
This product is protected by patents, design
patents, patents pending, or design patents
pending.
Declaration of conformity
This product conforms to the following
Electromagnetic Compatibility (EMC) regulations
and standards for use in marine environments.
CE EN 60945
FCC CFR 47, Part 15, Subpart B
DNV Std No. 2.4
IACS E10
GL GL VI 7.2
Correct installation according to Zipwake
documentation is required to ensure that EMC
performance is not compromised.
The product follows ABYC recommended
practices, E-11: AC and DC Electrical Systems on
Boats and H-27: Seacocks, thru-hull fittings and
drain plugs.
Zipwake Integrator Module is NMEA 2000®
certified (software release 4.0 or higher). NMEA
Network Message database version 3.000.
OPERATOR’S MANUAL
DYNAMIC TRIM CONTROL SYSTEM
FOR INTEGRATION
Part number: 2012311
Release: R2A, April 2024
Language: English
Copyright © 2024 Zipwake AB, Sweden. All rights reserved.
To Next Page
Loading...
