ZIPWAKE DYNAMIC TRIM CONTROL SYSTEM - FOR INTEGRATION28
15 MAINTENANCE
15.1 LAUNCH
15.2 HAUL-OUT
Paint the interceptors with anti-fouling paint before launching your boat. If possible use
spray paint (recommended). When the paint is dry, remove excess paint between the
interceptor blades. Before launching the boat, move the interceptor blades full strokes
using the controls to ensure that they move freely and correctly. Refer to the Installation
Guide for more information.
Verify acceptable servo torque levels by running an Interceptor Check (chapter 9.4).
After your boat has been hauled out of the water, use a pressure washer to remove any
growth or dirt on the interceptors. Fully extend the interceptor blades using the controls
and pressure wash them. Check the blades for damage. When washing is completed,
retract the interceptor blades by turning o the system. Check that the cable covers are
in place and not damaged. When the boat is hauled out after being in the water for an
extended time, we recommend temporarily removing the interceptor fronts and pressure
washing the inside of the interceptors thoroughly.
IMPORTANT When your boat is hauled out of the water, do not place any
supporting blocks pushing against the interceptors or blocking the
interceptor blades.
IMPORTANT Always use the controls to move the interceptor blades.
Never try to force the interceptor blades by hand.
WARNING Watch out for sharp edges when close to the interceptors.
To Next Page
Loading...
