The Trim Control System may affect the
course keeping of your boat. Always pay
close attention to steering the boat.
ATTENTION
OK
Integrator Module
Version 4.0
ZIPWAKE DYNAMIC TRIM CONTROL SYSTEM - FOR INTEGRATION 9
5 INITIAL START
5.1 SETTING UP THE SYSTEM
1. Initially, the ZIPWAKE logo on the
integrator module pulsates, and
becomes a steady blue light when
fully powered up.
Once powered up and the Zipwake
application is launched (chapter
3.3) on a connected MFD or mobile
device, read the ATTENTION text and
press OK or wait (7 sec) for the next
step.
NOTE! All selections made during Inital Start can be edited later from the System Menu.
2. Select Language and tap NEXT.
NOTE!
The system’s automatic control functions need correct boat data to work properly.
Hull length, max chine beam, and half load displacement are good choices.
3. Select Units and tap NEXT.
Metric: Kilograms, meters
Imperial: Pounds, feet
4. Enter boat length, beam, weight, hull
type (mono or catamaran) and tap
NEXT.
To Next Page
Loading...
