ZIPWAKE DYNAMIC TRIM CONTROL SYSTEM - FOR INTEGRATION10
5. Select the distribution unit installation(s) (DU installation) that represent the actual
installation (Single or DU-EX Port/Starboard side).
6. Verify that the Interceptor Configuration represents the actual installation and tap NEXT.
Single Distribution Unit Double Distribution Units
NOTE!
Refer to Interceptor Configuration (chapter 9.3) for more information.
NOTE!
If the orientation angle is dicult to measure or estimate, use a compass or a mobile
device compass application to determine the intergrator module’s angle relative the boats
forward direction within ±5°.
7. Make sure the integrator module orientation angle (mounting angle relative to the
boat’s forward direction) is set as accurately as possible according to the figures
below, then tap NEXT.
To Next Page
Loading...
