User Manual
Page | 26
Item Descriptions
IP Address
The factory default value is 192.168.1.201. Please set them according to the
actual network situation.
Subnet Mask
The factory default value is 255.255.255.0. Please set them according to the
actual network situation.
DNS
The factory default address is 0.0.0.0. Please set them according to the actual
network situation.
TCP COMM. Port
The factory default value is 4370. Please set them according to the actual
network situation.
DHCP
Dynamic Host Configuration Protocol helps in dynamically allocating IP
addresses for clients via server.
Display in Status Bar
To set whether to display the network icon on the status bar.
PC Connection
To improve the security of data, please set a Comm Key for communication between the device and the PC.
The connection password needs to be entered before the device can be connected to the PC software if a
Comm Key is set.
Select PC Connection on the Comm. Settings interface to set Comm Key.
Item Descriptions
Comm Key
The default password is 0, which can be changed later. The Comm Key may
contain1-6 digits.
Device ID
It is the identification number of the device, which ranges between 1 and 254. If
the communication method is RS232/RS485, you need to input this device ID in
the software communication interface.
Smart Access Control Terminal
To Next Page
Loading...
Need help?
General
