User Manual
Page | 33
Factory Reset
Restore the device settings to their factory state, such as communication settings, system settings, etc.
(Do not clear registered user data).
Select the Reset option on the System interface. Select OK to reset.
USB Upgrade
Insert the U disk with upgrade file into the device’s USB port, and in the initial interface, press [M/OK] >
System > USB Upgrade to complete firmware upgrade operation.
Select USB Upgrade option on the System interface.
Note: If an upgrade file is needed, please contact our technical support. Deny firmware upgrade under
normal circumstances.
Smart Access Control Terminal
To Next Page
Loading...
Need help?
General
