Zoom G11 - Page 45

3.
Select a category.
The category selection screen only appears when DYNMCS/FILTER or DELAY/REVERB is selected.
4.
Touch an amp or effect to select it. Then, touch OK.
The selected effect or amp will be enabled.
5.
Repeat steps 2–4 to select amps and effects.
If the AUTOSAVE function (
→
page95) is ON, the patch memory will be saved automatically.
If the AUTOSAVE function is OFF, touch
to open the patch memory saving screen. Follow the procedures
in “Saving patch memories” on page40 to save it.
HINT
See “Changing patch memory names” on page38 to change the patch memory name.
45