Zoom G11 - Creating New Patch Memories

Creating patch memories
New patch memories can be created.
1.
Touch on the Home Screen.
This opens a screen for patch memory creation.
Select effects
Select an amp
Select a speaker cabinet
The CREATE PATCH MEMORY screen starts with 4 effect categories, an amp and a speaker cabinet ready
for selection. Select the effects, amp and speaker that you like for each to create a patch memory.
• DYNMCS/FILTER: Compressors and other dynamics effects, as well as equalizers and other lter effects
• DRIVE: Distortion, overdrive and similar effects
• MOD: Chorus, anger and other modulation effects
• DELAY/REVERB: Delays, reverbs and other spatial effects
NOTE
• Up to 240 patch memories can be saved. If there are no openings, the patch memory creation screen will not
be shown. Delete an unneeded patch memory before creating a new one.
• To select effects in categories not shown on the patch memory creation screen, follow the procedures to add
effects after creating the patch memory. (
→
“Adding effects” on page31)
2.
Touch the icon for the effect, amp or speaker cabinet that you want to select.
44