Zoom G11 - Overdubbing Loops

Overdubbing loops
Additional performances can be added to the recorded loop.
This shows the looper status.
1.
Press during loop playback.
This starts overdubbing.
When the end of the loop is reached, loop playback will continue from the beginning, and overdubbing can be
repeated.
2.
Press during overdubbing.
This stops overdubbing, but continues loop playback.
█
Erasing the last overdub (UNDO)
Enable the UNDO function before using it (
→
“Turning the UNDO function ON/OFF” on page72).
1.
Press twice during loop playback.
█
Restoring an undone overdub (REDO function)
1.
After erasing an overdub, press twice again.
75