ZyXEL Communications 1050 - Page 125

Chapter 18 Application Patrol
ZyWALL (ZLD) CLI Reference Guide
125
18.2.5 General Commands for Application Patrol
" You must register for the IDP/AppPatrol signature service (at least the trial)
before you can use it. See Chapter 4 on page 37.
This table lists the general commands for application patrol.
show Displays the rule’s configuration
no app other <1..64> Deletes the specified rule.
app other move <1..64> to <1..64> Moves the specified rule (first index) to the
specified location. The process is (1) remove the
specified rule from the table; (2) re-number; (3)
insert the rule at the specified location.
Table 65 app Commands: Rules in Other Applications (continued)
COMMAND DESCRIPTION
Table 66 app Commands: Pre-Defined Applications
COMMAND DESCRIPTION
[no] app activate Turns on application patrol. The
no command
turns off application patrol.
[no] app protocol_name bandwidth-graph Sets the specified protocol to display on the
bandwidth statistics graph. The no command has it
not display on the bandwidth statistics graph.
[no] app other protocol_name bandwidth-graph Sets traffic for unidentified applications to display
on the bandwidth statistics graph. The no
command it not display on the bandwidth statistics
graph.
[no] bwm activate Globally enables bandwidth management. You
must globally activate bandwidth management to
have individual policy routes or application patrol
policies apply bandwidth management. The
no
command globally disables bandwidth
management.
show app config Displays whether or not application patrol is active.
show app all Displays the settings for all applications.
show app all defaultport Displays the default port settings for all
applications.
show app all statistics Displays statistics for all applications.
show app {general|im|p2p|stream} Displays protocols by category.
show app im support action Displays the supported actions of each Instant
Messenger application.
show app protocol_name config Displays the basic configuration of this application.
show app protocol_name defaultport Displays the default ports of this application.
show app protocol_name statistics Display the statistics of this application.
show app protocol_name rule <1..64> Displays the rule configuration of this application.