Chapter 18 Application Patrol
ZyWALL (ZLD) CLI Reference Guide
126
18.2.5.1 General Command Examples
The following examples show the information that is displayed by some of the
show
commands.
show app protocol_name rule <1..64> statistics Displays the rule statistics of this application.
show app protocol_name rule default Displays the default rule configuration of this
application.
show app protocol_name rule default statistics Displays the default rule statistics of this
application.
show app protocol_name rule all Displays the configurations of all the rules for this
application.
show app protocol_name rule all statistics Displays all the rule statistics for this application.
show app other config Displays the basic configuration for other
applications,
show app other statistics Displays statistics for other applications.
show app other rule <1..64> Displays the rule’s configuration.
show app other rule <1..64> statistics Displays the rule’s statistics.
show app other rule default Displays the default rule’s configuration.
show app other rule default statistics Displays the default rule’s statistics.
show app other rule all Displays the configurations of all the rules for other
applications.
show app other rule all statistics Displays all the rule statistics for other applications.
show bwm activation Displays whether or not the global setting for
bandwidth management on the ZyWALL is
enabled.
Table 66 app Commands: Pre-Defined Applications (continued)
COMMAND DESCRIPTION
Router> configure terminal
Router(config)# show bwm activation
bwm activation: yes
Router# configure terminal
Router(config)# show app http config
application: http
active: yes
mode: portless
default access: forward
bandwidth graph: yes
Router# configure terminal
Router(config)# show app http defaultport
No. Port
===========================================================================
1 80
To Next Page
Loading...
