Chapter 5 Interfaces
ZyWALL (ZLD) CLI Reference Guide
57
5.2.6 Basic Interface Setting Commands
This section identifies commands that support port grouping.
" In CLI, representative interfaces are called representative ports.
[no] ip ospf hello-interval <1..65535> Sets the number of seconds between “hello”
messages to peer routers. These messages let
peer routers know the ZyWALL is available. The
no command sets the number of seconds to 10.
See
ip ospf dead-interval for more
information.
[no] ip ospf dead-interval <1..65535> Sets the number of seconds the ZyWALL waits for
“hello” messages from peer routers before it
assumes the peer router is not available and
deletes associated routing information. The
no
command sets the number of seconds to 40. See
ip ospf hello-interval for more
information.
[no] ip ospf retransmit-interval
<1..65535>
Sets the number of seconds the ZyWALL waits for
an acknowledgment to a link state announcement
before it re-sends the link state announcement.
Table 19 interface Commands: OSPF Settings (continued)
COMMAND DESCRIPTION
Table 20 Basic Interface Setting Commands
COMMAND DESCRIPTION
show port-grouping Displays which physical ports are assigned to each
representative interface.
port-grouping ge<1..5> port <1..5> Adds the specified physical port to the specified
representative interface.
no port <1..5> Removes the specified physical port from its
current representative interface and adds it to its
default representative interface (port x --> gex).
port status Port<1..5> Enters a sub-command mode to configure the
specified port’s settings.
[no] duplex <full | half> Sets the port’s duplex mode. The no command
returns the default setting.
exit Leaves the sub-command mode.
[no] negotiation auto Sets the port to use auto-negotiation to determine
the port speed and duplex. The no command turns
off auto-negotiation.
[no] speed <100,10> Sets the Ethernet port’s connection speed in Mbps.
The no command returns the default setting.
show port setting Displays the Ethernet port negotation, duplex, and
speed settings.
show port status Displays statistics for the Ethernet ports.
To Next Page
Loading...
