Chapter 12 LAN
NBG6815 User’s Guide
104
12.6 IPv6 LAN Screen
Use this screen to configure the IP address for your NBG6815 on the LAN. Click Expert Mode >
LAN > IPv6 LAN.
Figure 69 Expert Mode > LAN > IPv6 LAN
The following table describes the labels in this screen.
Apply Click Apply to save your changes with the NBG6815.
Cancel Click Cancel to begin configuring this screen afresh.
Table 36 Expert Mode > LAN > Static DHCP (continued)
LABEL DESCRIPTION
Table 37 Expert Mode > LAN > IPv6 LAN
LABEL DESCRIPTION
LAN IPv6 Address Assignment
Enable_DHCPv6-PD
Select this option to use DHCPv6 prefix delegation. The NBG6815 will obtain an IPv6 prefix from the ISP or a
connected uplink router for the LAN.
Autoconfiguration
Type
Select SLAAC + RDNSS to enable IPv6 stateless auto-configuration on this interface.
The interface will generate an IPv6 IP address itself from a prefix obtained from an IPv6
router in the network.
Select SLAAC + Stateless DHCPv6 to enable IPv6 stateless auto-configuration on this
interface. The interface will get an IPv6 address from an IPv6 router and the DHCP
server. The IP address information gets through DHCPv6.
Select Stateful DHCPv6 to allow a DHCP server to assign and pass IPv6 network
addresses, prefixes and other configuration information to DHCP clients.
IPv6 Address range
(Start)
Enter the beginning of the range of IP addresses that this address object represents.
IPv6 Address range
(End)
Enter the end of the range of IP address that this address object represents.
To Next Page
Loading...
