Chapter 11 Wireless LAN
NBG6815 User’s Guide
97
11.7 WPS Screen
Use this screen to enable/disable WPS, view or generate a new PIN number and check current WPS
status. To open this screen, click Expert Mode > Wireless > WPS.
Note: With WPS, wireless clients can only connect to the wireless network using the first
SSID on the NBG6815.
Intra-BSS Traffic A Basic Service Set (BSS) exists when all communications between wireless clients or
between a wireless client and a wired network client go through one access point (AP).
Intra-BSS traffic is traffic between wireless clients in the BSS. When you Enable Intra-
BSS, wireless clients can access the wired network and communicate with each other.
When you Disable Intra-BSS, wireless clients can still access the wired network but
cannot communicate with each other.
Tx Power Set the output power of the NBG6815 in this field. If there is a high density of APs in an
area, decrease the output power of the NBG6815 to reduce interference with other APs.
Select one of the following 100%, 90%, 75%, 50%, 25% or 10%.
QoS Setup
WMM QoS Select Enable to have the NBG6815 automatically give a service a priority level
according to the ToS value in the IP header of packets it sends. WMM QoS (Wifi
MultiMedia Quality of Service) gives high priority to voice and video, which makes them
run more smoothly.
This field is not configurable and the NBG6815 automatically enables WMM QoS if you
select 802.11n, 802.11an, 802.11gn or 802.11bgn in the Expert > Wireless screen.
Apply Click Apply to save your changes back to the NBG6815.
Cancel Click Cancel to reload the previous configuration for this screen.
Table 32 Expert Mode > Wireless > Advanced (continued)
LABEL DESCRIPTION
To Next Page
Loading...
