Chapter 1 Introduction
NBG6815 User’s Guide
12
1 Make sure the power LED is on (not blinking).
2 Press the WPS button for more than three seconds and release it. Press the WPS button on another
WPS-enabled device within range of the NBG6815.
Note: You must activate WPS in the NBG6815 and in another wireless device within two
minutes of each other.
For more information on using WPS, see Section 8.2 on page 48.
1.7 LEDs
Figure 1 Front Panel
The following table describes the front panel LEDs.
Table 1 Front Panel LEDs
LED COLOR STATUS DESCRIPTION
Power/System White On The NBG6815 is receiving power and functioning properly.
Blinking The NBG6815 is in the process of starting up, default restoring,
or My ZyXEL Cloud Server online registration pairing.
Off The NBG6815 is not receiving power.
WLAN 2.4G
WLAN 5G
Power
Internet
WAN
WPS
USB
To Next Page
Loading...
