Chapter 7 Access Point Mode
NBG6815 User’s Guide
45
7.4.1 Navigation Panel
Use the menu in the navigation panel to configure NBG6815 features in Access Point Mode.
Figure 33 Expert Mode: Navigation Panel: Access Point Mode
Refer to Table 15 on page 38 for descriptions of the labels shown in the navigation panel.
7.5 LAN Screen
Use this section to configure your LAN settings while in Access Point Mode.
Click Expert Mode > LAN to see the screen below.
Note: If you change the IP address of the NBG6815 in the screen below, you will need to
log into the NBG6815 again using the new IP address.
Rate For the LAN ports, this displays the port speed and duplex setting or is left blank when the
line is disconnected.
For the 2.4GHz/5GHz WLAN, it displays the maximum transmission rate when the 2.4GHz/
5GHz WLAN is enabled and N/A when the WLAN is disabled.
Printer Information
Printer Name The NBG6815 can act as a print server and allows you to share a USB printer on your LAN.
This displays the
name of the printer connected to the NBG6815's USB port.
Note: You need to manually install the printer driver in your computer and add the printer to
your printer list.
Table 16 Expert Mode: Status > System Status: Access Point Mode (continued)
LABEL DESCRIPTION
To Next Page
Loading...
