Chapter 15 Maintenance
NBG6815 User’s Guide
137
Figure 89 Expert Mode > Maintenance > General
The following table describes the labels in this screen.
15.4 Password Screen
It is strongly recommended that you change your NBG6815's password.
If you forget your NBG6815's password (or IP address), you will need to reset the device. See
Section 15.8 on page 142 for details.
Click Expert Mode > Maintenance > Password. The screen appears as shown.
Figure 90 Expert Mode > Maintenance > Password
The following table describes the labels in this screen.
Table 51 Expert Mode > Maintenance > General
LABEL DESCRIPTION
System Name System Name is a unique name to identify the NBG6815 in an Ethernet network.
Domain Name Enter the domain name you want to give to the NBG6815.
Administrator
Inactivity Timer
Type how many minutes a management session can be left idle before the session times
out. The default is 5 minutes. After it times out you have to log in with your password
again. Very long idle timeouts may have security risks. A value of "0" means a
management session never times out, no matter how long it has been left idle (not
recommended).
Apply Click Apply to save your changes back to the NBG6815.
Cancel Click Cancel to begin configuring this screen afresh.
Table 52 Expert Mode > Maintenance > Password
LABEL DESCRIPTION
Old Password Type the default password or the existing password you use to access the system in
this field.
New Password Type your new system password (up to 30 characters). Note that as you type a
password, the screen displays an asterisk (*) for each character you type.
Retype to Confirm Type the new password again in this field.
To Next Page
Loading...
