Chapter 10 WAN
NBG6815 User’s Guide
81
10.6 Dynamic DNS Screen
To change your NBG6815’s DDNS, click Expert Mode > WAN > Dynamic DNS. The screen
appears as shown.
Figure 51 Expert Mode > WAN > Dynamic DNS
The following table describes the labels in this screen.
Apply Click Apply to save your changes back to the NBG6815.
Cancel Click Cancel to begin configuring this screen afresh.
Table 22 Expert Mode > WAN > NAT > Port Trigger (continued)
LABEL DESCRIPTION
Table 23 Expert Mode > WAN > Dynamic DNS
LABEL DESCRIPTION
Dynamic DNS Setup
Dynamic DNS Select Enable to use dynamic DNS. Select Disable to turn this feature off.
Service Provider Select the name of your Dynamic DNS service provider.
Host Name Enter a host names in the field provided. You can specify up to two host names in the
field separated by a comma (",").
Username Enter your user name.
Password Enter the password assigned to you.
Apply Click Apply to save your changes back to the NBG6815.
Cancel Click Cancel to begin configuring this screen afresh.
To Next Page
Loading...
