Chapter 15 Maintenance
NBG6815 User’s Guide
145
15.10.2 Wake On LAN
Wake On LAN (WoL) allows you to remotely turn on a device on the network, such as a computer,
storage device or media server. To use this feature the remote hardware (for example the network
adapter on a computer) must support Wake On LAN using the “Magic Packet” method.
You need to know the MAC address of the remote device. It may be on a label on the device.
Use this screen to remotely turn on a device on the network. Click the Expert Mode >
Maintenance > Remote Management > Wake On LAN to open the following screen.
Figure 98 Expert Mode > Maintenance > Remote Management > Wake On LAN
Port You may change the server port number for a service if needed, however you must use the
same port number in order to use that service for remote management.
Access Status Select the interface(s) through which a computer may access the NBG6815 using this
service.
Secured Client
IP Address
Select All to allow all computes to access the NBG6815.
Otherwise, check Selected and specify the IP address of the computer that can access the
NBG6815.
HTTPS
Port You may change the server port number for a service if needed, however you must use the
same port number in order to use that service for remote management.
Access Status Select the interface(s) through which a computer may access the NBG6815 using this
service.
Secured Client
IP Address
Select All to allow all computes to access the NBG6815.
Otherwise, check Selected and specify the IP address of the computer that can access the
NBG6815.
Apply Click Apply to save your changes back to the NBG6815.
Cancel Click Cancel to begin configuring this screen afresh.
Table 56 Expert Mode > Maintenance > Remote Management > WAN Access
LABEL DESCRIPTION
To Next Page
Loading...
