Chapter 11 Wireless LAN
NBG6815 User’s Guide
98
Figure 63 Expert Mode > Wireless > WPS
The following table describes the labels in this screen.
Table 33 Expert Mode > Wireless > WPS
LABEL DESCRIPTION
WPS Setup
Band Select the frequency band to set whether you want to apply the wireless and security
settings to the default 2.4GHz or 5GHz wireless LAN.
WPS Select Enable to turn on the WPS feature. Otherwise, select Disable.
PIN Code Select Enable and click Apply to allow the PIN Configuration method. If you select
Disable, you cannot create a new PIN number.
PIN Number This is the WPS PIN (Personal Identification Number) of the NBG6815. Enter this PIN in
the configuration utility of the device you want to connect to the NBG6815 using WPS.
The PIN is not necessary when you use WPS push-button method.
Click Generate to generate a new PIN number.
Push Button Use this button when you use the PBC (Push Button Configuration) method to configure
wireless stations’s wireless settings.
Click this to start WPS-aware wireless station scanning and the wireless security
information synchronization.
To Next Page
Loading...
