Chapter 13 Applications
NBG6815 User’s Guide
113
13.2.2.1 Add/Edit a Notification Rule
Click Add new rules in the Notification screen to add a new rule or click the Edit icon next to an
existing rule to edit it. Use this screen to set a schedule and have the NBG6815 send a notification
when the specified user connects to the NBG6815 at the scheduled time.
Figure 74 Expert Mode > Applications > Notification: Add/Edit new rules
Status This indicates whether the rule is active or not.
A yellow bulb signifies that this rule is active. A gray bulb signifies that this rule is not active.
User Name This shows the name of the user to which this rule applies.
Notification This shows the e-mail address to which the notification is sent.
Modify Click the Edit icon to go to the screen where you can edit the rule.
Click the Delete icon to delete an existing rule.
Email Notification Configuration
Mail Server Select the mail server. Otherwise, select UserDefined and manually specify the mail server
address and the port of the mail server.
Mail Server
Address
Type the name or IP address of the outgoing SMTP server.
Mail Server Port Enter the same port number here as is on the mail server for mail traffic.
Authentication
Username
Type the user name to provide to the SMTP server for authentication when the notification is
e-mailed.
Authentication
Password
Type the password to provide to the SMTP server for authentication when the notification is
e-mailed.
Mail From Type the e-mail address from which the outgoing e-mail is delivered. This address is used in
replies.
E-Mail Type the e-mail address (or addresses) to which the outgoing e-mail is delivered.
Apply Click Apply to save your changes.
Cancel Click Cancel to restore your previously saved settings.
Table 41 Expert Mode > Applications > Parental Control > Notification (continued)
LABEL DESCRIPTION
To Next Page
Loading...
